Sanitization Project for Dr. H.W. Bledsoe, MD.

Please examine the following laboratory reports and comments from the homeowner – Dr. H.W. Bledsoe of Lexington, S.C.:

Phase 1:

Air Quality sampling was conducted by Mold Solutions, Inc. and analyzed by EMSL Analytical, Inc., an independent 3rd party laboratory.

The report dated 03-06-08 shows a very poor Indoor Air Quality. Please note the extremely high count of Aspergillus/Penicillium when compared to the outside air.

With this information, mold remediation would be required.

Click the thumbnail to view the report from EMSL Analytical.

Report Thumbnail

Phase 2:

Varying surfaces were swab sampled on 02/28/08 and sent to EnviroScreening Lab, an independent 3rd party laboratory. Mold Solutions, Inc. conducted the testing and sent the swabs for culturing. The report came back on 03/06/08 and, when compared to the Acceptable Ranges Graph, there are elevated levels of viable mold contamination in several areas of the house including the HVAC return.

Click the thumbnails to view the reports from EnviroScreening Lab.

Report Thumbnail Report Thumbnail

Phase 3:

On 03/14/08 Dr. Bledsoe contracted with Absolute Air Care to post screen the air quality after the Mold Solutions, Inc. Sanitization Protocol was completed.

The reduction in the spore counts is dramatic. The Pre-Screen Report indicated 2 ½ times the spore count inside the Living Room when compared to the outside spore count. The Post Screen Report shows a spore count approximately 1/3 of the outside spore count.

This represents an extremely successful remediation considering the objective is to restore Indoor Air Quality to the levels which are measured outside the home. Outside air is considered normal for your particular environment.

Click the thumbnail to view the report from EMSL Analytical .

Report Thumbnail

Phase 4:

On 03/24/08 Dr. Bledsoe contracted again with Absolute Air Care to post screen the home’s interior surfaces for potential contamination.

Unbelievably, this report, as again provided by the EnviroScreening Lab, showed all surface contaminants had been removed or killed - an amazing result by anybody’s standards. The goal in mold remediation of surfaces is to reduce microbial contamination to normal or accepted levels, obviously Mold Solutions, Inc. has achieved excellence with our Sanitization Protocol. Please see Doctor Bledsoe’s testimony.

Click the thumbnails to view the reports from EnviroScreening Lab.

Report Thumbnail Report Thumbnail

Powered by WebNet Media Group
Mold Solutions Inc. All Rights Reserved